SKU
Description
Traditional floor mats either do not protect your entire floor board from damage or only protect your carts flooring against a select few elements. Dekomats is a golf cart floor protection mat that offers the highest durability of any floor mat on the market.
The Dekomat covers the entirety of the carts floor board as every mat is machine cut to match the exact make and model of your cart. Gone are the days of slapping a rubber rectangle on-top of your carts flooring, providing minimal protection as well as adding a cheap look to your cart.
The Dekomat is made of 100% polyvinyl material and will protect your carts floor board against every day wear and tear, equipment, oils, grease or battery acid. Further more, as a testament to the durability of The Dekomat every mat comes with a one year all Inclusive warranty!
Additionally, no expensive solvents or intensive labor is involved when cleaning the mat. The Dekomat can be cleaned with ease using only soap and water!
Traditional mats stain over time and become discolored or worn, The Dekomat will stay crystal clear and vibrant over the years to come. All other mats on the market are made of traditional rubber, carpet, and occasionally metal. These materials all provide some protection but yet all have their own pit falls. Rubber and carpet mats are susceptible to abrasions as well as staining and discoloration, on top of that some cleaning solvents can permanently damage the rubber or carpet mats. Metal mats are typically painted and because of this although they might protect against abrasions well, the paint will scratch and peel off leaving the bare metal exposed for corrosion.
а
а
Installation of the DekomatTM typically takes approximately 10 minutes, making updating to a new design a swift and effortless process. If a cart has custom components installed on the floor the mats can be simply cut/trimmed with a box knife, or scissors to compensate for the aftermarket equipment.
Upon receiving your new DekomatTM, please unroll the mat and lay it flat, leave the mat in this position for 12-24 hours so that the mat may acclimate to the ambient air temperature. Allowing your mat to acclimate properly will make installation easier.
*Tip: letting the mat lay in the sun can greatly speed up this process*
The tools you will need to complete the installation process consist of; a screwdriver with the bit to match your carts hardware (typically a star or Phillips head bit), and a razor, knife, or scissors if you have any aftermarket equipment on the floor of your golf cart.
Installation steps
1. Remove all hardware holding side rails in place, typically a Philips head screwdriver or Allen key. (if equipped with rivets, remove all rivets holding the mat in place)
2. Remove old floor mat, and clean the area where the new DekomatTM is to be installed so that it is free of dirt/debris.
3. Place the new Dekomat into position. Install the mat cut outs over the brake pedal, and then the accelerator pedal.
4. Smooth out and center mat. If necessary, trim edges to fit any aftermarket accessories that may be installed.
5. In the event that your cart model was equipped with rivets holding the old mat in place, re-insert the rivet screws into the new Dekomat in the holes provided.
6. Reinstall side rails with hardware that was removed during step one.
а
